HindlePower ATevo Series Operating/Service Instructions Manual page 52

HindlePower Inc
I/O Connections: Style-5054 Enclosure I/O Connections: Style-5054 Enclosure
PROCEDURE PROCEDURE
1. Remove safety shield per
2. Run ac input supply wiring into ATevo, ending at the AC Input Circuit Breaker (CB1) and
ground stud.
3. Connect wires to appropriate locations on AC Input Circuit Breaker (CB1-L1/L2) and
system ground stud, as indicated on the drawing above.
4. Using a flat-blade screwdriver, securely tighten the compression screws on AC Breaker
(CB1-L1/L2).
5. Securely tighten ground wire on system ground stud.
6. Check all connections and reinstall safety shield.
Copyright HindlePower Inc. 2021
Section 2.2, Removing Protective Safety
ATevo O&SI - 1PH Input Group I (6-25 Adc) - 1.1_en
Shield.
Last modified: 3 August 2023
Page 52 of 316