Verifying Multi-Tap Ac Input Voltage Setting - HindlePower ATevo Series Operating/Service Instructions Manual

HindlePower Inc
2.3.3. 2.3.3. Modifying Multi-Tap AC Input Modifying Multi-Tap AC Input
Voltage Setting Voltage Setting
Before changing the voltage selection jumper, shut down ATevo and lock out
ac and dc power supplies. Turning off (opening) the ATevo internal circuit
breakers does not eliminate live voltages inside the enclosure.
STEPS STEPS
• Standard flat blade screwdriver is required.
• Follow instructions in
• Locate the multi-tap terminal block.
• Set locations of
Verifying Multi-Tap AC Input Voltage
◦ Carefully pry out jumpers in existing locations.
◦ Re-install jumpers into new (correct) locations.
• Re-check jumper locations and confirm jumpers are properly
seated.
Copyright HindlePower Inc. 2021
Section 2.2, Removing Protective Safety
RED RED jumpers for desired ac input voltage, according to
Setting.
ATevo O&SI - 1PH Input Group I (6-25 Adc) - 1.1_en
Shield.
Last modified: 18 July 2023
Section 2.3.2,
Page 50 of 316