HindlePower ATevo Series Operating/Service Instructions Manual page 161

HindlePower Inc
An SDHC memory card 32GB or less is required. The procedure can take up to 4.5 minutes to
perform.
Update Procedure Update Procedure
1. Copy the firmware update file received from your supplier to the SD card using either a
personal computer (PC) with an SD Memory Card slot, or a USB to SD Memory Card
adapter.
2. Open the ATevo front panel door, and locate the SD Memory Card socket on the back of
the Main Control Board (A1).
3. Insert the SD card into the SD Memory Card socket on the ATevo main board.
4. Directly below the socket will be a jumper JP4 (RE-FLASH ENABLE), as seen in the image
below. Move the jumper to the PGM position.
5. If the charger is already powered, press the RESET button on the main board, otherwise
simply power the charger. The screen below will list all available firmware updates from
the latest to the earliest. Use the UP/DOWN arrow keys to select the update to apply, then
press ENTER.
Copyright HindlePower Inc. 2021
ATevo O&SI - 1PH Input Group I (6-25 Adc) - 1.1_en
Page 161 of 316