Important Safety Instructions - HindlePower AT30 SERIES Operating And Service Instructions

Microprocessor-controlled float battery charger three phase input (25 - 1,000 adc)

Hide thumbs Also See for AT30 SERIES:

Operating instruction (8 pages)

Operating and service instructions (108 pages)

Operating instructions manual (44 pages)

Table Of Contents

100

Table of Contents

PLEASE READ AND FOLLOW

ALL SAFETY INSTRUCTIONS

1. Before using the AT30, read all instructions and cautionary markings on:

A) this equipment, B) battery, and C) any other equipment to be used in

conjunction with the AT30.

2. This manual contains important safety and operating instructions, and should

therefore be filed for easy access.

3. Remove all jewelry, watches, rings, etc. before proceeding with installation or

service.

4. Maintain at least 6in / 152mm of free air on all vented surfaces for cooling.

Allow sufficient clearance to open the front panel for servicing.

5. Connect or disconnect the battery only when the AT30 is off, to prevent

arcing or burning.

6. Do not operate the AT30 if it has been damaged in any way. Refer to

qualified service personnel.

7. Do not disassemble the AT30. Only qualified service personnel should

attempt repairs. Incorrect reassembly may result in explosion, electrical

shock, or fire.

8. Do not install the AT30 outdoors, or in wet or damp locations, unless

specifically ordered for that environment.

9. Do not use the AT30 for any purpose not described in this manual.

1. Do not touch any uninsulated parts of the AT30, especially the input and

output connections, as there is the possibility of electrical shock.

2. During normal operation, batteries may produce explosive gas. Never smoke,

use an open flame, or create arcs in the vicinity of the AT30 or the battery.

3. Turn the AT30 off before connecting or disconnecting the battery to avoid a

shock hazard and/or equipment damage.

4. De-energize and lock out all ac and dc power sources to the AT30 before

servicing.

5. Do not operate the AT30 with any power source that does not match the

specified ac and dc voltage ratings. Refer to the data nameplate decal affixed

to the outside panel for operational requirements.

6. Do not operate the AT30 with the Plexiglas safety shield or any other supplied

guards removed or improperly installed.