HindlePower ATevo Series Operating/Service Instructions Manual page 132

HindlePower Inc
5.1.4. 5.1.4. Lamp Test & Display of Firmware Lamp Test & Display of Firmware
Versions Versions
ATevo has a Lamp Test mode that is activated by pressing and holding the DOWN arrow button.
The Lamp Test will turn ON all front panel LEDs (except for the AC ON LED) and keep them on
until the DOWN arrow button is released. The AC ON LED will be lit during normal operating
conditions because it is driven by the power supply, and is not under software control.
When DOWN is released, ATevo will briefly display the charger's installed firmware versions,
then return to the HOME screen and resume normal operation.
*
The ATevo Lamp Test is identical to the Lamp Test on legacy AT10.1 Series
battery chargers.
Copyright HindlePower Inc. 2021
ATevo O&SI - 1PH Input Group I (6-25 Adc) - 1.1_en
Last modified: 8 September 2023
Page 132 of 316