HindlePower ATevo Series Operating/Service Instructions Manual page 208

HindlePower Inc
11.3. 11.3. Procedure for Wiring Remote Procedure for Wiring Remote
Sense Sense
Route twisted-pair cable between the battery and ATevo. Make the connections listed below
befor before e moving the Remote Sense enable jumpers to enable the Remote Sense.
Preparation: Preparation:
• Open both front panel breakers (CB1/CB2).
• De-energize and lock out all ac and dc voltages to ATevo.
• Allow internal voltages to dissipate.
• Use #16 AWG twisted-pair wire, of appropriate length to reach from the battery to ATevo.
• Designate, or label label, one (1) wire of twisted pair as 'DC(+)
• Designate the other wire of the twisted pair as 'DC( – )
• Route one (1) end of the twisted pair remote sense wiring to BATTERY, at the desired
battery sense location.
• Open ATevo front panel door, and remove safety shield.
• Verify no hazardous voltages are present with a voltmeter.
• Locate the Power Board (A2) on the left side of ATevo.
• Refer to image below.
• Identify the 3-position REMOTE SENSE terminal block (A2-TB1) at the bottom-front of the
board.
• Route other end of twisted pair wiring to terminal block.
Wiring Wiring
• Connect wire from twisted-pair designated as 'DC(+)
• Connect wire designated as 'DC( – )
• Observing correct polarity, connect battery end of 'DC(+)
location on the battery.
• Confirm polarity and connect battery end of 'DC( – )
on the battery.
• Verify polarity of POS and NEG battery connections.
• DO NOT energize ATevo until you configure Remote Sense jumpers per
• After Remote Sense Jumpers have been correctly configured, replace the safety shield and
re-energize ATevo.
Copyright HindlePower Inc. 2021
ATevo O&SI - 1PH Input Group I (6-25 Adc) - 1.1_en
DC( – )'.
DC(+)' to terminal (A2-
DC( – )' to terminal (A2-
DC( – )' wire to a negative(-) sense location
'DC(+)'.
A2-TB1-
A2-TB1- TB1-NEG NEG)
DC(+)' wire to a positive sense
TB1-POS POS).
Section 11.4.
Page 208 of 316