Starting Up - HindlePower ATevo Series Operating/Service Instructions Manual
Hide thumbs
Also See for ATevo Series:
- Operating/service instructions manual (164 pages) ,
- Operations (173 pages) ,
- Operating/service instructions manual (311 pages)
Table of Contents
Advertisement
HindlePower Inc
4.1.4.
4.1.4. Starting Up
Starting Up
After confirming that all connections to ATevo are properly made, start up as follows:
1. Turn ON (close) AC Input Circuit Breaker (CB1) first.
You should hear a soft hum from ATevo as output increases. ATevo LCD should start up and
indicate dc output voltage. If the display does not light, do not proceed. Turn OFF (open)
the AC Breaker (CB1) and recheck connections.
!
If you attempt to turn ON the DC Output Circuit Breaker (CB2) first, it may trip
due to the filter capacitor in-rush.
2. Turn ON (close) the DC Output Circuit Breaker (CB2).
If any error codes or alarms appear on the Main ATevo Display and/or Alarm Indicator LEDs,
refer to
Section 8, Alarms & Indicators
indication before proceeding.
Copyright HindlePower Inc. 2021
ATevo O&SI - 1PH Input Group I (6-25 Adc) - 1.1_en
to interpret the origin and resolution of the
Last modified: 3 August 2023
Page 86 of 316
Advertisement
Table of Contents
