HindlePower ATevo Series Operating/Service Instructions Manual page 284
Hide thumbs
Also See for ATevo Series:
- Operating/service instructions manual (164 pages) ,
- Operations (173 pages) ,
- Operating/service instructions manual (311 pages)
Table of Contents
Advertisement
HindlePower Inc
For ATevos with Multi-tap Transformers:
For ATevos with Multi-tap Transformers:
• Route H1, H2, H3, H4, and H5 primary wires to associated terminals on Multi-Tap Terminal
Block (TB-H#). Insert primary wires into labeled positions of terminal block and tighten
screws.
For All ATevos:
For All ATevos:
• Route X1 and X4 secondary wires from Transformer (T1) to X1 and X4 lugs on Power Board
(A2).
• Insert wires into lugs and tighten.
• Route Y1 and Y2 wires from Transformer (T1) to terminal block on Power Board (A2-TB11).
• Install wires into terminal block and tighten screws.
• Check your work.
• Replace safety shield and close the front panel door.
• Restart ATevo.
Copyright HindlePower Inc. 2021
ATevo O&SI - 1PH Input Group I (6-25 Adc) - 1.1_en
Last modified: 2 August 2023
Page 284 of 316
Advertisement
Table of Contents
