HindlePower ATevo Series Operating/Service Instructions Manual page 281

HindlePower Inc
14.3.9. 14.3.9. Replacing Eliminator Filter Replacing Eliminator Filter
Capacitor (C2) – optional Capacitor (C2) – optional
• See also Service Instruction (JD5078-02).
The optional eliminator filter (C2) consists of a single electrolytic capacitor with two (2) wires
connected directly to the Power Board (A2).
Preparation: Preparation:
• Shut down and lock out all power to ATevo.
• Remove safety shield and check with a voltmeter.
• Locate the 'blue can' capacitor (C2), at the bottom-left of ATevo, secured to the
galvanized base with two (2) nylon zip ties.
Removal of Existing Capacitor: Removal of Existing Capacitor:
• Cut the plastic ties and disconnect wires from the Power Board (A2).
• Remove the wired capacitor. Replacement capacitor (C2) is supplied with new wires and
pre-crimped terminals.
*
The pos(+) and neg(-) wires have different terminals to eliminate the possibility
of connecting in reverse polarity.
Installation of Replacement Capacitor Assembly: Installation of Replacement Capacitor Assembly:
• Connect wires of new capacitor assembly (C2) to Power Board.
• Mount replacement cap to ATevo base with provided wire ties.
• Replace safety shield, and close front panel door.
• Restart ATevo.
Copyright HindlePower Inc. 2021
ATevo O&SI - 1PH Input Group I (6-25 Adc) - 1.1_en
Last modified: 2 August 2023
Page 281 of 316