HindlePower ATevo Series Operating/Service Instructions Manual page 211

HindlePower Inc
11.5. 11.5. Disabling Remote Sense Disabling Remote Sense
If you need to temporarily disable Remote Sense:
• De-energize and lock out all ac and dc voltages within the ATevo enclosure.
• Check with a voltmeter.
• Remove the safety shield.
• Move SHORTING BLOCKs to Local Sense configuration per
• Replace safety shield and close front panel door.
• Re-energize ATevo.
*
If Remote Sense is to be disabled for extended periods of time or permanently
disabled, it is highly recommended that the sense leads (the twisted pair cable)
be disconnected from both the battery and terminal block (A2-TB1).
Copyright HindlePower Inc. 2021
ATevo O&SI - 1PH Input Group I (6-25 Adc) - 1.1_en
Section 11.4.3.
Last modified: 2 August 2023
Page 211 of 316