HindlePower ATevo Series Operating/Service Instructions Manual page 90

HindlePower Inc
4.2.1. 4.2.1. How to Configure General How to Configure General
Parameter Settings Parameter Settings
You can adjust ATevo settings during operation using the front panel controls. When you first
press EDIT/ENTER on the front panel, ATevo prompts you to set the first of six (6) basic charger
parameters (Float Voltage).
To set parameters, do the following:
• Press UP or DOWN (or hold down to scroll) until desired value displays. Each parameter
has a minimum and maximum limit as listed in
• Press EDIT/ENTER to save setting. ATevo prompts you to set the next parameter.
• Continue in the same manner to set all six (6) parameters in the list. If you want to skip
setting any parameter, press EDIT/ENTER (or RIGHT arrow) to bypass it.
• When finished setting the sixth parameter (Current Limit), press EDIT/ENTER to save
setting and return to normal operation.
• Any changes made take effect immediately; ATevo uses its last saved values if it is
powered down and returned to service.
*
The Basic ATevo Set Point mode can also be entered from the Main Menu by
selecting the BASIC SETTINGS icon.
!
If you are interrupted while adjusting settings and do not press a front panel key
for 10 minutes, Edit Mode ends automatically without saving adjustments to any
setting not previously saved with the EDIT/ENTER key.
Copyright HindlePower Inc. 2021
ATevo O&SI - 1PH Input Group I (6-25 Adc) - 1.1_en
Section 4.1.2, Factory Settings Tables.
Last modified: 19 July 2023
Page 90 of 316