Table of Contents
Advertisement
Chapter 20 System Utility Function Setting
Auto Config
You can set the parameters for the AUTO menu.
Press Utility → More → Auto Config, and set the parameters for the AUTO key.
For detailed settings, refer to descriptions in "Quick Measurement after AUTO".
Print Setting
Connect the oscilloscope to the local area network via the network cable. The
MSO8000 series supports printing the whole screen to the network printer. You can
connect the oscilloscope to the printer directly via the USB DEVICE interface on the
rear panel. Then, you can set the print parameters on the oscilloscope to control the
printer to output the corresponding picture.
Press Utility → More → Printer to enter the printer setting menu. After the printer
is properly connected, you need to set the network configurations for printing, and
then set the printer parameters.
1. Network Configuration
Press Setting to enter the network configuration menu.
Select the Printer
⚫
Press Printer, and rotate the multifunction knob
model. Press down the knob to select it. You can also press Printer
continuously or enable the touch screen to select it.
Set the IP Address
⚫
Press Printer IP, then rotate the multifunction knob
segment of the IP address for the printer. Press down the knob to confirm
the setting for each segment of the address. At this time, the cursor is
moved to the next segment automatically. You can also press Printer IP
continuously to switch the segment position, and then rotate the
multifunction knob
switch the address segment.
Set the Port
⚫
Press Printer Port, rotate the multifunction knob
number or use the pop-up numeric keypad to input the port number.
Network Test
⚫
Press Test to test whether the network is connected. If connected, a
prompt message "Network connected" is displayed.
Print Test Page
⚫
MSO8000 User Guide
to set it. You can also enable the touch screen to
RIGOL
to select the printer
to set each
to adjust the port
20-11
Advertisement
Table of Contents
