Auto Measurement; Quick Measurement After Auto - Rigol DS1000Z-E Series User Manual

Chapter 6 MATH and Measurement

Auto Measurement

DS1000Z-E provides auto measurements of 37 waveform parameters and the
statistics and analysis of the measurement results. What's more, you can also use
the frequency counter to realize more precise frequency measurement.

Quick Measurement after AUTO

When the oscilloscope is correctly connected and has detected valid input signal,
press AUTO to enable the waveform auto setting function and open the following
function menu:
Figure 6-2 Function Menu after AUTO
Note:
than 41 Hz; the duty cycle should be greater than 1% and the amplitude must be at
least 20 mVpp for square. Otherwise, the Waveform auto setting function may be
invalid and the quick parameter measurement function displayed in the menu will
also be unavailable.
DS1000Z-E User Guide
Find Quality Products Online at:
Single-period: set the oscilloscope to display single-period signal
automatically. Measure the "Period" and "Frequency" of the
current signal within a single period and display the measurement
results at the bottom of the screen.
Multi-period: set the oscilloscope to display multi-period signal
automatically. Measure the "Period" and "Frequency" of the
current signal within multiple periods and display the
measurement results at the bottom of the screen.
Rise Time: measure the "Rise Time" of the current signal and
display the measurement result at the bottom of the screen.
Fall Time: measure the "Fall Time" of the current signal and
display the measurement result at the bottom of the screen.
Back: return to the menu displayed at the last user setting.
Undo: cancel the automatic settings and restore the parameters
set by users lastly.
Waveform auto setting function requires that the frequency of sine is no lower
GlobalTestSupply
www.
RIGOL
6-23
.com
sales@GlobalTestSupply.com