Starter Solenoid - Polaris RZR 900 2015 Service Manual

Table of Contents

STARTER SOLENOID

Starter Solenoid Bench Test

Test the start solenoid by powering the solenoid using

battery voltage for a maximum of 5 seconds. With the

solenoid energized, resistance should read about 0 - 0.5

ohms between terminals (A) and (B). If resistance

measurement is out of specification, replace the starter

Starter Solenoid Operation

To energize the Starter Solenoid the following must

• The brake must be applied to provide a ground path

via the orange wire.

• The key switch must be turned to the "start" position to

provide 12V power via the Green / White wire.

• Once the pull-in coil is energized, the solenoid

provides a current path for 12V power to reach the

starter motor.

See "ELECTRICAL SYSTEM BREAKOUTS: Starter-

Interlock" provided in this chapter for starter

solenoid operation.

Starter Solenoid Cable Fasteners:

35 in-lb (4 Nm)

9926814 R08 -

2015-2016 RZR 900

2016 RZR S 1000 Service

Table of Contents