Polaris RZR 900 2015 Service Manual page 310

PVT SYSTEM
DRIVEN CLUTCH DISASSEMBLY
1. Mark the position of the clutch sheaves before clutch
removal or use the X's on the sheaves for reference.
This aids in reassembly and maintains clutch balance
after reassembly.
2. Remove the drive belt (see "Belt Removal", page
).
3. Remove the driven clutch retaining bolt and washer.
4. Remove driven clutch from the transmission input
shaft and install it on a universal clutch compressor
(PU-50518). Spin the tool down until it touches the
spring cup.
5. Remove the five Torx screws
spring cover to the inner clutch sheave.
6. Turn the compression tool handle counter-clockwise
to relieve spring
compressor tool from the clutch assembly.
9926814 R08 -
5.36
q
that secure the
pressure and remove
7. Remove the spring cover
8. Remove the spring.
9. Rotate the moveable sheave counter-clockwise to
release it from the rollers on the stationary sheave.
Note if there is a thrust washer
sheaves.
the
2015-2016 RZR 900
w e
and spring cup .
r
between the
2016 RZR S 1000 Service
Manual
© Copyright Polaris Industries Inc.