Polaris RZR 900 2015 Service Manual page 328

TRANSMISSION
11. Torque right side mounting bolts to specification using
the numbered sequence shown.
TORQUE
Engine / Transmission Mounting Bolts:
Step 1-2: 64 ft-lb (87 Nm)
Step 3: 5 ft-lb (7 Nm)
Step 4-7: 44 ft-lb (60 Nm)
12. Remove the clutch center distance tool.
13. Remove the spacer or support between the vehicle
frame and engine.
14. Install and properly route the gear position switch
r
connector , speed sensor connector
position sensor connector
u
bracket bolts , shift cable clevis pin and washer
onto the transmission.
15. Torque the two shift cable bracket bolts to
specification.
TORQUE
Shift Cable Bracket Bolts:
17 ft-lb (23 Nm)
9926814 R08 -
6.12
t
, crankshaft
y
, shift bracket and shift
i
2015-2016 RZR 900
16. Install three wire ties to retain wire harness to
transmission and mounts.
17. Install and properly route the vent hose
18. Lubricate the transmission splines and mid prop shaft
joint splines with Polaris All Purpose Grease. Install
the propshaft onto the transmission output shaft (see
Chapter 7 – Prop Shaft Installation, page 7.20).
19. Install inner clutch cover, outlet duct, drive clutch,
driven clutch, belt and outer clutch cover (see
Chapter 5 – PVT Assembly, page
20. Install new spring ring
an anti-seize compound to the splines
o
.
).
a
on rear drive shafts. Apply
s
.
2016 RZR S 1000 Service
Manual
© Copyright Polaris Industries Inc.