Rear Carrier Bearing Replacement - Polaris RZR 900 2015 Service Manual

Table of Contents

REAR CARRIER BEARING REPLACEMENT

1. Remove the outer snap ring

2. From the back side of the bearing carrier, tap on the

outer bearing race with a drift punch in the reliefs as

3. Drive bearing out evenly by tapping on outer race

only. Once bearing is at bottom of casting, support

casting on outer edges so bearing can be removed.

4. Inspect the bearing carrier housing for scratches,

wear or damage. Replace rear bearing carrier if

5. Thoroughly clean the rear bearing carrier housing

and the outer race on the new bearing. Be sure that

all oil residue has been removed from each surface.

6. Support the bottom of the bearing carrier housing.

Use an arbor and press only on the outer race or

bearing damage may occur.

9926814 R08 -

7. Apply Loctite® 603™ retaining compound to the

8. Wipe the housing clean of any excess compound and

2015-2016 RZR 900

outer circumference of the new bearing race

carefully press the new bearing into the bearing

carrier housing

Use care to not allow any of the Loctite® compound to

get in the bearing.

install the snap ring

2016 RZR S 1000 Service

Table of Contents