Cooling System Bleeding - Polaris RZR 900 2015 Service Manual

ENGINE / COOLING SYSTEM
5. Remove the two bolts
cover to the engine.
6. Remove the thermostat cover, seal
y
from the engine.
NOTE
Thermostat has a pop-off relief to allow the bypass
system to operate until the thermostat opens.
7. Clean the thermostat mating surfaces on the engine
and thermostat cover.
8. Install a new thermostat and seal into the cover and
install the cover onto the engine.
9. Install the thermostat cover bolts. Torque bolts to
specification.
TORQUE
Thermostat Cover Bolts:
7 ft-lb (10 Nm)
10. Install coolant hose back on the thermostat cover and
securely tighten the hose clamp.
11. Fill cooling system and proceed to bleed the cooling
system (see Chapter 3 – Cooling System Bleeding
Procedure, page ).
9926814 R08 -
3.16
r
that retain the thermostat
t
and thermostat
2015-2016 RZR 900

COOLING SYSTEM BLEEDING

WARNING
Always wear safety glasses and proper shop clothing
when performing the procedures in this manual. Failing
to do so may lead to injury or death.
NOTE
If the coolant level is LOW in the radiator or if there are
leaks in the system, the cooling system will not draw
coolant from the reservoir tank.
1. Allow engine and cooling system to cool down.
CAUTION
Escaping steam can cause burns. Never remove the
pressure cap while the engine is warm or hot. Always
allow the engine to cool before removing the pressure
2. Remove the hood.
3. Remove the cap from the Coolant Reservoir
fill the reservoir to the MAX line.
4. Remove the radiator pressure cap
necessary amount of Polaris Premium Antifreeze to
the radiator.
5. Remove the cargo box engine access panel.
cap.
q
w
and add the
2016 RZR S 1000 Service
Manual
© Copyright Polaris Industries Inc.
and