21. Align the splines of the drive shaft with the
transmission splines. Push inward on the control arm
assembly until the rear drive shafts lock into the
transmission splines.
d
22. Install new fasteners
retaining the upper control
arms to the bearing carriers on each side. Torque to
specification.
23. Install the stabilizer bar link mounting bolts and new
f
nuts
. Torque to specification.
24. Install rear wheels, wheel nuts and hub castle nuts.
Torque to specification.
TORQUE
Stabilizer Bar Linkage:
40 ft-lbs (54 Nm)
Wheel Nuts:
Aluminum: 120 ft-lbs (163 Nm)
Steel: 60 ft-lb (81 Nm)
Hub Castle Nuts:
180 ft-lbs (244 Nm)
25. Properly lower the vehicle.
9926814 R08 -
Manual
© Copyright Polaris Industries Inc.
26. Install the air box assembly as outlined in the EFI
Chapter (see Chapter 4 – ETC Replacement, page
4.24.
27. Install the rear bumper and cargo box as an assembly
(see Chapter 5 – Rear Cargo Box / Fenders, page
10.16).
28. Connect the (-) negative battery cable.
29. Install the engine service panel
seats
30. If transmission lubricant was drained, fill the
transmission with the specified amount of Polaris
AGL (see Chapter 2 – Transmission Lubrication,
page 2.26.
Recommended Transmission Lubricant:
2015-2016 RZR 900
TRANSMISSION
g
, console cover and
j
.
FLUID CAPACITY
AGL (PN 2878068) (Quart)
Capacity: 44 oz. (1300 ml)
2016 RZR S 1000 Service
6
6.13