Clutch Bushing Installation - Polaris RZR 900 2015 Service Manual

PVT SYSTEM
9. Install left hand nut and spacer onto puller rod and
tighten by hand. Turn puller barrel for further tension if
needed.
10. Turn clutch sheave counterclockwise until bushing is
removed and sheave comes free.
11. Remove nut (left hand thread) from puller rod and set
aside.
12. Remove adapters from puller.
13. Remove bushing and removal tool from adapters.
Discard bushing.

CLUTCH BUSHING INSTALLATION

1. Install Number Two Puller Adapter
2. Install the Adapter Reducer
3. Apply Loctite® 648 evenly to bushing bore inside
moveable sheave.
4. Install sheave face down on puller.
9926814 R08 -
5.30
a
onto puller.
o
onto puller.
2015-2016 RZR 900
5. Install new bushing on installation tool
assembly into sheave.
6. Install left hand thread nut onto puller rod and hand
tighten against installation tool.
7. Turn clutch sheave counterclockwise, making sure
bushing is drawn straight into bore. Continue until
bushing is seated.
8. Remove nut from puller rod and set aside.
9. Remove installation tool and clutch sheave from
puller.
w
and install
2016 RZR S 1000 Service
Manual
© Copyright Polaris Industries Inc.