Polaris RZR 900 2015 Service Manual page 221

10. Remove the valve tappet from a valve that was out of
specification.
NOTE
Keep mated parts together and in order with respect to
their location in the cylinder head for assembly
purposes. Mark each component or place them in an
organized rack as you remove them.
11. Record the 3 digit number on the bottom of the
i
tappet. .
12. Reference the valve
recorded for that valve, along with the 3-digit tappet
number.
13. Refer to the appropriate tappet selection matrix
(Intake or Exhaust) on the following pages and select
the proper tappet.
14. Install the proper tappet.
NOTE
Lubricate the outer portion of the valve tappet upon
installation.
15. Repeat steps 10-14 until all necessary valves have
been adjusted.
9926814 R08 -
Manual
© Copyright Polaris Industries Inc.
clearance measurement
2015-2016 RZR 900
ENGINE / COOLING SYSTEM
16. Reinstall the camshafts and camshaft carriers and
tighten the bolts evenly to specification.
TORQUE
Camshaft Carrier Bolts:
7 ft-lb (10 Nm)
17. Measure and confirm that valve clearance is now
within specification for each valve.
18. If valve clearance is not within specification, repeat
this procedure.
19. If all valve clearance measurements are now within
specification, remove the camshaft carriers and
proceed to Camshaft Installation / Timing, page
3.137.
2016 RZR S 1000 Service
3
3.143