Driven Clutch Assembly - Polaris RZR 900 2015 Service Manual

DRIVEN CLUTCH ASSEMBLY

q
1. Install a new bearing onto the clutch shaft using an
arbor press. Once bearing is fully seated, install a
w
new snap ring .
2. Install the shaft and bearing assembly into the outer
sheave using an arbor press.
NOTE
Press only on the outer race of the bearing during
installation to prevent damaging the bearing.
9926814 R08 -
Manual
© Copyright Polaris Industries Inc.
3. Line up the X on the moveable sheave with the X on
the stationary sheave. Put the sheaves together.
4. Install the rollers
on the clutch.
5. Install the roller pin into the sheave assembly on both
sides. The flat side of the roller pin faces towards the
sheaves.
2015-2016 RZR 900
PVT SYSTEM
e r
onto the roller pins and install
2016 RZR S 1000 Service
5
5.31