Polaris RZR 900 2015 Service Manual page 348

TRANSMISSION
29. Install the detent pawl onto the shift shaft and
carefully install the compression spring.
30. Install a new O-ring on each shift shaft
small amount of white lithium grease on the O-rings,
shift shafts and component contact surfaces prior to
installing the sector cover.
31. Clean the transmission and gear sector cover mating
surfaces thoroughly.
32. Apply Crankcase Sealant (3-Bond) onto the cover
and transmission case mating surface.
Crankcase 3 Bond Sealant
PN 2871557
33. Install the sector cover and align the transmission
case dowel with the alignment hole. Install and torque
the bolts to specification.
TORQUE
Sector Gear Cover Bolts:
12 ft-lb (16 Nm)
34. Install the transmission drain plug and torque to
specification.
9926814 R08 -
6.32
35. Install the bellcrank onto the shift shaft. Note the key
splined on the bellcrank and shift shaft. Install the nut
and torque to specification.
36. Refer to Transmission Installation, page 6.10 to
complete the repair.
3^
. Apply a
2015-2016 RZR 900
TORQUE
Fill / Drain Plug:
14 ft-lbs (19 Nm)
TORQUE
Bell Crank Nut:
18 ft-lb (24 Nm)
2016 RZR S 1000 Service
© Copyright Polaris Industries Inc.
Manual