Crankshaft Removal / Inspection - Polaris RZR 900 2015 Service Manual

ENGINE / COOLING SYSTEM
5. Measure each bearing journal in two locations, 90
degrees apart. Replace balance shaft if either journal
is worn below the service limit specification. If worn
past the service limit, replace the balance shaft
assembly.
MEASUREMENT
Balance Shaft Diameter (MAG & PTO):
1.4939 - 1.4946" (37.946 - 37.962 mm)
Service Limit:
1.4921" (37.900 mm)
9926814 R08 -
3.112

CRANKSHAFT REMOVAL / INSPECTION

1. Perform Crankcase Disassembly / Inspection, page
3.109 procedure.
2. Perform Balance Shaft Removal / Inspection, page
3.111 procedure.
3. For ease of assembly, mark each connecting rod and
end cap.
4. Loosen, remove and discard the four connecting rod
q
bolts . Remove the end caps from the crankshaft.
5. Carefully lift the crankshaft
6. Remove the cam chain
and PTO main seal
2015-2016 RZR 900
w
out of the crankcase.
e
, oil pump drive chain
r
from the crankshaft.
2016 RZR S 1000 Service
© Copyright Polaris Industries Inc.
t
Manual