Polaris RZR 900 2015 Service Manual page 132

ENGINE / COOLING SYSTEM
8. Remove and clean oil pump pick-up
9. Remove the three bolts
to the crankcase.
10. Use one of the oil pump retaining bolts or a pen
magnet to extract the dowel pins
pump. Doing so allows for oil pump removal without
having to remove the pump drive sprocket.
NOTE
If unable to extract the dowel pins from the oil pump,
the oil pump sprocket must be removed. Access the
sprocket bolt by removing the case plug.
9926814 R08 -
3.54
i
.
o
that retain the oil pump
s
from the oil
2015-2016 RZR 900
11. Lift the oil pump drive chain and remove the oil
pump.
a
12. Visually inspect the oil pump and drive sprocket
for wear or damage. Replace oil pump drive chain
and sprocket if worn or damaged. If any part of the oil
pump is damaged, the entire assembly must be
replaced. Replace the oil pump seal
crankcase assembly.
Oil pump assembly is non-serviceable
13. Rotate the engine so the cylinder is facing up.
f
NOTE
2016 RZR S 1000 Service
© Copyright Polaris Industries Inc.
d
during
Manual