CPS REPLACEMENT
1. Access the CPS harness from the right rear side of
the vehicle.
2. Disconnect the CPS harness connector.
3. Remove CPS retaining bolt
w
from the stator cover.
4. Remove CPS wire lead from wire clip
5. Install new sensor using a light coating of oil on the
O-ring to aid installation.
6. Torque CPS retaining bolt to specification.
TORQUE
CPS Retaining Bolt:
9 ft-lb (12 Nm)
7. Route CPS wire lead through wire clip and reconnect
CPS harness connector.
9926814 R08 -
Manual
© Copyright Polaris Industries Inc.
q
and remove the sensor
e
.
2015-2016 RZR 900
FUEL SYSTEM
2016 RZR S 1000 Service
4.23
4