Engine Disassembly / Inspection - Lower End (900); Stator Cover Removal / Inspection - Polaris RZR 900 2015 Service Manual

ENGINE DISASSEMBLY / INSPECTION -
LOWER END (900)

STATOR COVER REMOVAL / INSPECTION

NOTE
The stator cover can be removed with the engine
installed in the chassis.
1. Remove the thirteen screws retaining the stator
cover.
CAUTION
The flywheel contains powerful magnets. Use caution
when removing and installing the stator cover. DO NOT
place fingers between cover and crankcase at any time
during the removal / installation process or injury could
result.
9926814 R08 -
Manual
© Copyright Polaris Industries Inc.
2. Carefully pry the stator cover off the engine using the
two pry areas as shown below.
3. Inspect the condition of the stator windings
output wires
Chapter 10.
4. Inspect the ball bearing that supports the starter
motor shaft.
2015-2016 RZR 900
ENGINE / COOLING SYSTEM
w
. If replacement is required, refer to
2016 RZR S 1000 Service
3
q
and
3.49