CLUTCH BUSHING INSTALLATION
1. Install Number Two Puller Adapter
2. Install the Adapter Reducer
3. Apply Loctite® 648 evenly to bushing bore inside
moveable sheave.
4. Install sheave face down on puller.
5. Install new bushing on installation tool
assembly into sheave.
6. Install left hand thread nut onto puller rod and hand
tighten against installation tool.
9926813 R04 - 2013-2016 RZR 570 Service Manual
© Copyright Polaris Industries Inc.
a
onto puller.
o
onto puller.
w
and install
7. Turn clutch sheave counterclockwise, making sure
bushing is drawn straight into bore. Continue until
bushing is seated.
8. Remove nut from puller rod and set aside.
9. Remove installation tool and clutch sheave from
puller.
DRIVEN CLUTCH ASSEMBLY
q
1. Install a new bearing
onto the clutch shaft using an
arbor press. Once bearing is fully seated, install a
w
new snap ring
.
2. Install the shaft and bearing assembly into the outer
sheave using an arbor press.
NOTE
Press only on the outer race of the bearing during
installation to prevent damaging the bearing.
PVT SYSTEM
5
5.33