PVT SYSTEM
10. Press the shaft and bearing out of the outer sheave
using an arbor press.
d
11. Inspect the bearing
the bearing does not spin smoothly, replace it. To
replace the bearing, remove the snap ring
end of the shaft and press the bearing off the shaft.
12. Inspect the cam (helix) assembly bushing
If the bushing is worn or the shaft does not fit snug
into the bushing, replace the cam (helix) assembly.
13. Inspect the sheaves for excessive wear or damage.
5.26
for wear. Spin the bearing, if
f
from the
g
for wear.
DRIVEN CLUTCH ASSEMBLY
BEARING INSTALLATION
1. Install a new bearing
arbor press. Once bearing is fully seated, install a
w
new snap ring
.
2. Install the shaft and bearing assembly into the outer
sheave using an arbor press.
Press only on the outer race of the bearing during
installation to prevent damaging the bearing.
q
onto the clutch shaft using an
NOTE