Starter One-Way Clutch Installation; Flywheel Installation - Polaris RANGER 500 2017 Service Manual

STARTER ONE-WAY CLUTCH
INSTALLATION
1. Install one-way clutch in clutch hub with flange of
q
clutch facing the flywheel.
NOTICE
The one-way clutch can be installed into the hub
incorrectly. This will cause engine cranking issues.
2. Clean screw threads in flywheel to remove all oil or
grease.
3. Apply Loctite® 272™ on the one way clutch retaining
w
bolts threads . Place hub on flywheel and install
bolts.
4. Torque screws to specification.
TORQUE
One Way Clutch Retaining Bolts:
1st: 6 ft-lbs (8 Nm)2nd: 9 ft-lbs (12 Nm) Apply
Loctite® 272™
9850043 R01 - 2017-2021 RANGER 500 / 570 Service Manual
© Copyright Polaris Inc.
ENGINE / COOLING SYSTEM

FLYWHEEL INSTALLATION

q
1. Clean the threads , taper
crankshaft to remove all oil or grease.
r
2. Clean flywheel taper with alcohol to remove all oil
or grease.
3. Apply a small amount of PS4 engine oil to the flat
t
area on the MAG side crankshaft. DO NOT apply
engine oil to the crankshaft taper.
4. Rotate crankshaft so the flywheel key
upward.
w e
and flat of
3
y
is facing
3.85