HEIDENHAIN MSE 1000 Operating Instructions Manual page 88

8
Commissioning and preparing to measure
8.1 Network configuration
Observe the power consumption ratings of the modules and any devices
connected to a module. Insert an additional power supply module as required.
Further Information:
Turn the power on.
The power LED's on each module should light solid green. Network LED's initially
flash green five times per second when waiting for DHCP to assign an IP address.
Wait for the Network LED to flash green twice per second on all modules.
Perform a broadcast, see "Connection", page 81.
Click the OK button in the dialog box when asked to switch to static addressing.
Turn the power off.
Install up to ten more modules into the module chain.
Turn the power on.
Wait for the Network LED to flash green twice per second on all modules.
Perform a broadcast.
Click the OK button in the dialog box when asked to switch to static addressing.
Repeat turning the power off, installing up to ten modules, turning the power
on, broadcasting, and switching to static addressing until all modules in the
module chain have a unique IP address.
88
CAUTION
"Module specifications", page 167.
HEIDENHAIN | MSE 1000 | Operating Instructions | 10/2015