Update Firmware - HEIDENHAIN MSE 1000 Operating Instructions Manual

7.4.12

Update firmware

The Update firmware screen provides options for updating the firmware and
bootloader installed on MSE 1000 modules. Update firmware is available only
when supervisor mode is enabled.
Update firmware
Do not update the firmware when Use DHCP addressing is enabled.
Further Information:
Programming the firmware with a version newer than v1.0.2 requires the
bootloader be at least v1.0.2.
The bootloader and firmware cannot be programmed to a version older than
v1.0.3 once programmed to v1.0.3 or newer.
To update the module firmware:
Click the Open button.
The file dialog window opens.
Use the File dialog window controls to select a firmware file to load.
Click the Module selection drop-down arrow and select a single module to
update or All to update all modules.
Modules will not be programmed if the new version matches the current version
when All is selected.
If required, click the Firmware/Bootloader button and select Firmware.
Click the OK button.
The firmware update begins. Refer to the status indicator for the current status of
the update.
HEIDENHAIN | MSE 1000 | Operating Instructions | 10/2015
NOTICE
"Module Chain", page 84.
NOTICE
MSEsetup configuration
7
7.4
75