HEIDENHAIN MSE 1000 Operating Instructions Manual page 110

8
Commissioning and preparing to measure
8.5 Referencing
Perform referencing
To perform referencing:
Move an encoder to have reference mark crossings recognized.
The Tree status will change to a solid "ref" when an encoder has been successfully
referenced.
Repeat crossing reference marks for all encoders with referencing enabled.
Click the OK button.
A message verifying the action is displayed in the message area.
Skip referencing
To skip referencing:
Enable supervisor mode.
Click the Back button.
Click the OK button.
A message verifying the action is displayed in the message area. The Tree status
will remain a flashing "!ref" when an encoder has not been referenced.
110
HEIDENHAIN | MSE 1000 | Operating Instructions | 10/2015