HEIDENHAIN MSE 1000 Operating Instructions Manual page 132

10
Installation and commissioning examples
10.2 Example using manual IP address assignment
Open the Configuration screen
Click the Config button.
Enable Supervisor mode
Click the Supervisor mode button.
Enter "95148" into the Password field.
Open the Connect screen
Click the Connect button.
Configure the Workstation IP
Select 172.31.46.3 from the Workstation IP drop-down list.
Select 255.255.255.0 from the Netmask drop-down list.
Further Information:
Perform a Broadcast
Click the Broadcast button.
A dialog box appears asking to configure the modules using a backup file.
Click the Cancel button.
A dialog box appears asking to configure the modules to use static addressing.
Click the OK button.
A dialog box appears verifying the modules have been set to use static addressing
and requesting to cycle power.
Cycle the power
Turn the power off, wait 20 seconds then turn the power on.
Wait for the Network LED's to flash twice per second on all modules.
Click the OK button in the dialog box.
Click the Cancel button when requested to overwrite the settings from a
backup file.
132
"Workstation IP", page 79.
HEIDENHAIN | MSE 1000 | Operating Instructions | 10/2015