Connecting A Transducer; Connecting An I/O Terminal Block Connector - HEIDENHAIN MSE 1000 Operating Instructions Manual

Table of Contents

5.2.7

Connecting a transducer

Transducer connector

This product can be used with select Solartron, Tesa, Marposs and Mahr half-

bridge and LVDT transducers. Refer to the transducer documentation for maximum

connecting cable length.

To connect a transducer:

Verify power is removed from all power supply modules in the module chain.

Align the transducer cable connector notch with the module transducer

connection notch

Insert the cable connector into the transducer connection

cable connector by turning clockwise until it is snug

5.2.8

I/O terminal block connector

The MSE 1401 (ID 747507-01) provides a terminal block I/O connection for

switching inputs and relay outputs. The switching inputs are active when a

High signal (contact or pulse) is present. They are isolated and can be supplied

externally or internally.

Further Information:

To connect the terminal block:

Verify that power is off or disconnected.

Remove the male terminal connector from the module connection.

Insert the required + and - wires for switching inputs or the required output

wire for relay outputs into their respective terminals on the male terminal

connector.

Using a small flat-edge screwdriver, tighten the screws located on the top of

the cable connector.

Insert the male terminal connector into the connection on the module.

HEIDENHAIN | MSE 1000 | Operating Instructions | 10/2015

"Relay outputs", page 179.

"Switching inputs", page 179.

Data interface connections

and tighten the

5.2

Table of Contents