Setup The 1 Vpp Encoder; Setup The Endat Channel; Setup The Endat Encoder - HEIDENHAIN MSE 1000 Operating Instructions Manual

10
Installation and commissioning examples
10.2 Example using manual IP address assignment
10.2.17 Setup the 1 V
Open the device tab
Click the Device tab.
Select the reference mark setting
Click the Reference mark drop-down arrow.
Select Single.
Select the Signal period setting
Click the Signal period (um) drop-down arrow.
Select 20.
Click the OK button.
Further Information:

10.2.18 Setup the EnDat channel

Select the EnDat Channel
Click on X11 (CH5) under MSE 1314 in the Tree.
Click the Channel tab.
EnDat encoder types are automatically recognized when an EnDat encoder is
connected to a module channel.
Further Information:
options.

10.2.19 Setup the EnDat encoder

Open the Device tab
Click the Device tab.
Turn Error monitoring off
Disabling error monitoring is useful for increasing communication speed with
EnDat v2.2 encoders.
Click the Error monitoring drop-down arrow.
Select Off.
Click the OK button.
Further Information:
136
encoder
PP
"Device setup", page 103 for additional device settings.
"Channel setup", page 97 for additional channel settings
"Device setup", page 103 for additional device settings.
HEIDENHAIN | MSE 1000 | Operating Instructions | 10/2015