Referencing - HEIDENHAIN MSE 1000 Operating Instructions Manual

8.5

Referencing

Referencing is used to obtain an absolute position for 1 V
When referencing is required the warning button will flash yellow and "Referencing
has not been completed" will be displayed in the message area. A referencing
status will be displayed in the Tree for encoders that require referencing.
!ref: Solid - Reference mark disabled for the device.
!ref: Flashing - Referencing is required, but not complete.
ref: Solid - Referencing is complete.
The Setup, Data, Mastering, and Diagnostics screens are not available until
referencing is complete.
Referencing is recommended, but can be skipped if an operation does not require
use of the encoders with referencing enabled.
Referencing must be completed when:
MSEsetup is opened
A Reconnect is performed
Reference mark setting is changed
Referencing screen
HEIDENHAIN | MSE 1000 | Operating Instructions | 10/2015
and TTL encoders.
PP
Signal period setting is changed
Line count setting is changed
Interpolation setting is changed
Referencing 8.5
109
8