Connecting A Network Cable; Connecting An Endat Encoder - HEIDENHAIN MSE 1000 Operating Instructions Manual

5.2.2

Connecting a network cable

15
RJ-45 connector
MSE modules communicate with a PC workstation through an RJ-45 connection
15 located on the base module. Use a straight-through cable when connecting to a
DHCP router. A crossover cable may be required when connecting the workstation
directly to the base module. Refer to the documentation provided with the NIC for
additional information.
To connect a network cable:
Verify power is removed from all power supply modules in the module chain.
With the cable connector locking tab facing up, insert the cable connector into
the RJ-45 connection
5.2.3

Connecting an EnDat encoder

16
EnDat encoder connector
This product can be used with HEIDENHAIN length gauges, linear encoders and
rotary encoders that provide EnDat signals. The connecting cable must not exceed
100 meters in length.
To connect an EnDat encoder:
Verify power is removed from all power supply modules in the module chain.
Align the encoder cable connector notch with the module encoder connection
notch.
Insert the cable connector into the encoder connection
connector by turning clockwise until it is snug.
HEIDENHAIN | MSE 1000 | Operating Instructions | 10/2015
15 on the module until the tab locks into place.
Data interface connections
16 and tighten the cable
5
5.2
43