HEIDENHAIN MSE 1000 Operating Instructions Manual page 85

To use DHCP addressing:
Click the Use DHCP Addressing button.
A dialog box confirms that all modules have been set to DHCP addressing.
Cycle power for the entire module chain by turning the power off and then back
on.
The Network LED on each module will flash five times per second while waiting
for DHCP to assign an IP address. The Network LED on each module will flash
twice per second when an address has been assigned.
Wait for the Network LED to flash twice per second on all modules.
Click the OK button in the dialog box.
MSEsetup performs a broadcast. Each modules Network LED will flash twice per
second until MSEsetup obtains a connection to the module. A dialog box confirms
the number of modules found.
Click the OK button in the dialog box to overwrite the configurable module
settings with a backup file or the Cancel button to skip overwriting the the
settings.
A message is displayed in the Connect screen message area when broadcasting is
finished.
Restore factory defaults
The Restore Factory Defaults option sets all of the modules in the module chain to
the factory default network settings.
Default network settings:
Module
MSE 120x
MSE 11xx,
MSE 13xx,
MSE 1401,
MSE 1501
HEIDENHAIN | MSE 1000 | Operating Instructions | 10/2015
IP address Subnet
172.31.46.2 255.255.255.0 27300
172.31.46.1
Network configuration
Asynchro- Addressing
nous port
DHCP
8
8.1
85