Releasing A Module - HEIDENHAIN MSE 1000 Operating Instructions Manual

4.5

Releasing a module

To release a module:
Verify all power switches are in the off position (if applicable) and power is
removed from all power supply modules in the module chain.
Press a flat-edge screwdriver into the lock tab receiver
left of the right hand module and press down on the lock tab
module to release the module.
Gently apply upward pressure, depressing the DIN rail spring 32.
While maintaining upward pressure, rotate the top of the module away from
the DIN rail.
Gently release the upward pressure, releasing the module from the DIN rail.
HEIDENHAIN | MSE 1000 | Operating Instructions | 10/2015
Releasing a module
29 opening at the top
7 of the left hand
4
4.5
37