Connecting A Cable With An M8 Connector; Connecting And Disconnecting A Compressed Air Tube - HEIDENHAIN MSE 1000 Operating Instructions Manual

5.2.11

Connecting a cable with an M8 connector

23, 24
M8 connectors
Covers are provided for I/O connections. Leave the cover on unused connections.
To connect a cable with an M8 connector:
Verify that power is off or disconnected.
Remove the connector cover by turning counterclockwise using a flat-edge
screw driver.
Align the cable connector with the module connector.
Insert the cable connector into the connector on the front of the module.
Hand tighten the M8 cable connector onto the module.
5.2.12

Connecting and disconnecting a compressed air tube

26, 28
Compressed air connector
The MSE 1501 provides 4 mm tube connections for compressed air input and
output.
To connect a compressed air tube:
Verify that power is off or disconnected.
Insert the 4 mm tube into the connector on the front of the module.
To disconnect a compressed air tube:
Verify that power is off or disconnected.
Push in on the blue connector ring and remove the 4 mm tube.
HEIDENHAIN | MSE 1000 | Operating Instructions | 10/2015
25
Data interface connections
5
5.2
47