Basic Network Troubleshooting - HEIDENHAIN MSE 1000 Operating Instructions Manual

12
Troubleshooting
12.13 Network troubleshooting
Ipconfig
Ipconfig can be used to show the IP address, netmask, and default gateway of all
network adapters.
To use IpConfig:
Open a command line program.
Enter "ipconfig" into the command line.
Press Enter on the keyboard.
Locate the network adapter that is being used to connect to the MSE 1000
modules and note the following information:
IP address
Subnet mask
If using DHCP:
Default gateway
Router IP address

12.13.2 Basic network troubleshooting

Verify power and LED's
Power cycle the workstation, router, and modules.
Verify that the Link LED on the workstation and router (if applicable) are lit.
Verify that the Network bus LED on the base module is lit.
Verify workstation NIC settings
Verify that the networking settings for the workstation NIC are configured
correctly. Refer to the documentation provided with the PC or NIC for
instructions.
DHCP IP address assignment:
automatically.
Static IP address assignment:
netmask to the required values. The subnet and netmask of the workstation and
modules must match.
162
Configure the NIC to Obtain an IP address
Manually configure the NIC IP address and
HEIDENHAIN | MSE 1000 | Operating Instructions | 10/2015