Connecting An I/O Terminal Block Power Connector; Wiring An M8 Connector - HEIDENHAIN MSE 1000 Operating Instructions Manual

Table of Contents

Installation

5.2

Data interface connections

5.2.9

Connecting an I/O terminal block power connector

I/O terminal block power connector

The MSE 1401 (ID 747507-01) provides a terminal block connection for 5 V power

output, external power input and GND for use with relay outputs.

Further Information:

To connect the terminal block power connector:

Verify that power is off or disconnected.

Remove the male terminal connector from the module connection.

Insert the required 5 V, Ext+ and GND wires into their respective terminals on

the male terminal connector based on power requirements.

Using a small flat-edge screwdriver, tighten the screws located on the top of

the connector.

Insert the male terminal connector into the connection on the module.

5.2.10

The MSE 1401 (ID 747507-0x) includes two M8 male connectors (ID 1071953-01)

for switching inputs and relay outputs. A female M8 connector (ID 1071955-01) is

included for 5 V power output, external power input and GND for use with relay

outputs. Additional connectors can be purchased from HEIDENHAIN. Wire the

power connector based on power requirements. M8 connectors need to be wired

to a suitable cable.

Further Information:

To wire an M8 connector:

Verify that power is off or disconnected.

Wire the connector according to the illustration shown above.

"Connecting an I/O terminal block connector", page 45

"Relay outputs", page 179.

"Connector pin assignments", page 176

"Switching inputs", page 179

"Relay outputs", page 179.

HEIDENHAIN | MSE 1000 | Operating Instructions | 10/2015

Table of Contents