Recovering From Ip Address Conflicts - HEIDENHAIN MSE 1000 Operating Instructions Manual

12
Troubleshooting
12.13 Network troubleshooting

12.13.3 Recovering from IP address conflicts

Restoring modules to factory default settings and following the procedures
described here will help recover from communication problems if a subnet or
netmask conflict is discovered while troubleshooting.
Recovering with DHCP
Recovering with DHCP IP address assignment:
Restore Factory Defaults, see "Module Chain", page 84.
Restoring factory defaults will set all of the modules to Use DHCP addressing. The
modules will obtain an IP address and netmask from the DHCP router.
Configure the module chain with DHCP , see "Configuring the module chain with
DHCP", page 87.
Recovering manually
Recovering with static IP address assignment:
Restore Factory Defaults, see "Module Chain", page 84.
Restoring factory defaults will set all of the modules to Use DHCP addressing.
The modules will timeout after 45 seconds waiting to obtain an IP address and
netmask.
Configure the module chain manually, see "Configuring the module chain
manually", page 89.
164
HEIDENHAIN | MSE 1000 | Operating Instructions | 10/2015