Example Using Manual Ip Address Assignment; Mount The Power Supply And Base Modules; Connect The Power Cord; Connect The Networking Cable - HEIDENHAIN MSE 1000 Operating Instructions Manual

10
Installation and commissioning examples
10.2

Example using manual IP address assignment

10.2 Example using manual IP address assignment
The following information provides an example for how to install and commission
an MSE 1000 system with three modules and two encoders using manual IP
address assignment.
MSE 1000 modules with encoders:
MSE 1201 (ID 747501-01) AC 120 V power supply module
MSE 1184 (ID 747500-01) 1 V
MSE 1314 (ID 747503-01) 4-channel EnDat module with one AT1217 length
gauge
10.2.1

Mount the power supply and base modules

Mount power supply module
Mount the MSE 1201 (ID 747501-01) power supply module, see "Mounting a
module", page 34.
Mount base module
Mount the MSE 1184 (ID 747500-01) 1 V
module", page 34.
Connect power supply and base module
Connect the power supply module and the base module, see "Connecting
modules", page 35.
10.2.2

Connect the power cord

Connect the power cord
Connect the power cord to the MSE 1201 (ID 747501-01) power cord connector
4, see "Connecting a power cord", page 42.
10.2.3

Connect the networking cable

A crossover cable may be required when connecting the workstation directly to
the base module. In this example a crossover cable is being used. Refer to the
documentation provided with the NIC to verify if a crossover cable is required.
Connect the base module to the workstation
Connect one end of an RJ-45 network crossover cable to the RJ-45 connection
15 on the MSE 1184 (ID 747500-01) 1 V
network cable", page 43.
Connect the other end of the network crossover cable to the workstation NIC.
Refer to the documentation provided with the workstation PC for instructions.
130
base module with one ST 128x length gauge
PP
base module, see "Mounting a
PP
base module, see "Connecting a
PP
HEIDENHAIN | MSE 1000 | Operating Instructions | 10/2015