Connecting A Ttl Encoder; Connecting A 1 Vpp Encoder; Connecting A 9-Pin D-Sub Connector - HEIDENHAIN MSE 1000 Operating Instructions Manual

5
Installation
5.2 Data interface connections
5.2.4

Connecting a TTL encoder

17
TTL encoder connector
This product can be used with HEIDENHAIN encoders that provide TTL signals.
The connecting cable must not exceed 30 meters in length.
To connect a TTL encoder:
Verify power is removed from all power supply modules in the module chain.
Connect the encoder cable connector to the encoder connection
module and tighten the cable connector screws until they are snug
5.2.5 Connecting a 1 V
18
1 V encoder connector
PP
This product can be used with HEIDENHAIN linear and rotary encoders that
provide 1 V
To connect a 1 V
Verify power is removed from all power supply modules in the module chain.
Connect the encoder cable connector to the encoder connection
module and tighten the cable connector screws until they are snug.
5.2.6

Connecting a 9-pin D-sub connector

19
9-pin D-sub connector
This product provides a 9-pin D-sub connector for input of analog signals. The
connecting cable must not exceed 30 meters in length.
To connect a 9-pin D-sub connector:
Verify power is removed from all power supply modules in the module chain.
Connect the cable connector to the 9-pin D-sub connection
and tighten the cable connector screws until they are snug
44
encoder
PP
signals. The connecting cable must not exceed 30 meters in length.
PP
encoder:
PP
17 on the
18 on the
19 on the module
HEIDENHAIN | MSE 1000 | Operating Instructions | 10/2015