HEIDENHAIN MSE 1000 Operating Instructions Manual page 76

7
Software setup
7.4 MSEsetup configuration
Update bootloader
Programming the bootloader is not recommended unless there is a mandatory
update. If the bootloader is not programmed correctly the affected modules
must be sent to HEIDENHAIN for service.
To update the module bootloader:
Click the Open button.
The File dialog window opens.
Use the File dialog window controls to select a bootloader file to load.
Click the Module selection drop-down arrow and select a single module to
update or All to update all modules.
Modules will not be programmed if the new version matches the current version
when All is selected.
If required, click the Firmware/Bootloader button and select Bootloader.
Click the OK button.
The bootloader update begins. Refer to the status indicator for the current status
of the update.
76
NOTICE
HEIDENHAIN | MSE 1000 | Operating Instructions | 10/2015