Installing End Covers; Installing Cable Mounting Hardware - HEIDENHAIN MSE 1000 Operating Instructions Manual

4
Mounting
4.4

Installing cable mounting hardware

4.3

Installing end covers

Left and right end cover kits are provided with each power supply module for
covering open module ends.
To install end covers:
Insert the left end cover into the left side of the first power supply module in
the chain.
Insert 19 mm end cover screws through the end cover mounting holes and into
the end cover screw holes
Using a cross-head screwdriver, tighten the screws.
Install the right end cover onto the right side of the last module in the chain
using the provided 9 mm screws and following the instructions given above.
4.4 Installing cable mounting hardware
A cable mounting hardware kit is provided with each module for routing cables.
Each kit contains two sets of mounting hardware.
To install cable mounting hardware:
Insert the M3 hex nut into the cable mounting slot
module.
Insert the M3 screw through the cable tie holder and fasten to the M3 hex nut
using a cross-head screwdriver.
Insert the cable tie through the cable tie holder and fasten cables.
36
34 on the module.
36 on the bottom of the
HEIDENHAIN | MSE 1000 | Operating Instructions | 10/2015