HEIDENHAIN MSE 1000 Operating Instructions Manual page 166

13
Decommissioning
13.4 Release all modules
13.2 Disconnect power cords
Disconnect the power cords attached to all power supply modules in the module
chain.
MSE 1201 (ID 747501-01)
To disconnect the MSE 1201 (ID 747501-01) power cord:
Verify that the power switch is in the off position.
Verify that the power cord is not plugged into the main power supply.
Remove the female end of the power cord from the power connector
front of the module.
MSE 1201 (ID 747501-02)
To disconnect the MSE 1201 (ID 747501-02) power cord:
Verify that there is no power at the source.
Un-wire the power cable from the source.
MSE 1202 (ID 747502-0x)
To disconnect the MSE 1202 (ID 747502-0x) power cord:
Verify that the power cord is not plugged into the main power supply.
Turn the connector counterclockwise to loosen the M8 connector.
Remove the power cord connector from the power connector
the module.
13.3 Disconnect data interface connections
Data interface connections vary based on individual MSE 1000 system
configurations, see "Data interface connections", page 42 for additional information
on available connections.
To disconnect data interface connections:
Disconnect all data interface connections by reversing the installation
instructions, see "Data interface connections", page 42.
Remove all device cables and mounting accessories.
13.4 Release all modules
For instructions on releasing modules, see "Releasing a module", page 37.
166
4 on the
13 on the front of
HEIDENHAIN | MSE 1000 | Operating Instructions | 10/2015