Table 2-13 Error Code C8-3 Paper Jam Clear Areas B,C - Xerox DOCUPRINT N4525 Service Quick Reference Manual

RAP 2-10
Error Code C8-3
There is a problem with the Tray 3 Take Away Sensor.
Logic Control on the Print Engine Controller Board sensed the Tray 3 Take Away Sensor
was on while the printer was in standby.

Table 2-13 Error Code C8-3 Paper Jam Clear Areas B,C

Step Actions and Questions
1 TRAY 3 TAKE AWAY SENSOR INSPECTION
Remove Tray 3 and inspect the Tray 3 Take Away
Sensor for paper scraps that may be actuating the
sensor.
Is the Sensor free of paper scraps?
TRAY 3 TAKE AWAY SENSOR TEST
2
1. Enter Diagnostic Mode.
2. From the Main Menu, select Comp Input Test / HCF
Unit / T/A Roll3 Sensor.
3. Press [4] to start test, [0] to stop.
4. Insert, then remove, a sheet of paper into the Tray 3
Take Away Sensor.
Does the Control Panel display "With Paper"
when you insert the paper into the Tray 3 Take
Away Sensor, and does the Control Panel
display "Without Paper" when you remove the
paper?
3 HIGH CAPACITY FEEDER BOARD
REPLACEMENT
Replace the High Capacity Feeder Board [RRP 2-9
High Capacity Feeder Board (PL 12.2)].
Does the error code appear?
4 INPUT/OUTPUT BOARD REPLACEMENT
Replace the I/O Board [RRP 1-70 Input/Output Board
(PL 11.2)].
Does the error code appear?
5 PRINT ENGINE CONTROLLER BOARD
REPLACEMENT
Replace the Print Engine Controller Board [RRP 1-72
Print Engine Controller Board (PL 11.3)].
Does the error code appear?
6 The following printer components and areas are
associated with this specific problem. One or more of
these components or areas may have failed partially or
completely. If you cannot isolate this problem using the
steps in this FIP, replace each component or
troubleshoot each area listed below, one at a time, until
you isolate and solve the problem.
Wiring and connectors linking the components.


Volume 2 / High Capacity Feeder - Error Codes
Paper Jam
Clear Areas B,C
Yes
Go to step 2
Go to step 3
Go to step 4
Go to step 5
Go to step 6
No
Remove the
paper scraps
Replace the
Tray 3 Take
Away
Sensor [PL
5.2]
Problem
solved
Problem
solved
Problem
solved
2-391